How To Clean Bathtub By Baking Soda And Other Ways

Clean a Bathtub with Baking Soda

If you want to clean bathtub, don’t use a store-bought cleaner with harsh chemicals and harmful ingredients. Instead, go to your pantry and get a box of baking soda to make a cleaner for your bathtub. Baking soda is a safe way to clean that can eliminate even the most stubborn stains and bathtub rings.

Put warm water on a sponge and squeeze out the extra water. Sprinkle baking soda all over the sponge, then scrub your bathtub. Start at the top and use a circular motion to work your way down to the bottom of the tub.

Rinse the sponge more and more, and add more baking soda as needed. Make sure to pay close attention to the drain and the area under the faucet where water tends to drip.

If the bottom of the tub is particularly grimy due to the non-slip surface, moisten the base and sprinkle baking soda directly on it. Let the baking soda sit for at least an hour to get into the dirt and grime.

Take the sponge and scrub the whole bath again. Then, run cold water over it to eliminate the baking soda.

Baking Soda With Vinegar

Pour the vinegar into a large bowl or measuring cup that can go in the microwave. This will remove hard water stains from a bathtub or remove soap scum. Mix the cornstarch and vinegar. Stir the ingredients with a fork until the cornstarch is dissolved and everything is well mixed.

Cook the container for two minutes in the microwave. Put the dishwashing liquid in the spray bottle. Take the vinegar and cornstarch out of the microwave and let them cool down for a few minutes. Pour the liquid over the dish soap in the spray bottle.

Shake the bottle gently to mix the ingredients. Put the spray bottle’s top back on. Spray the soap scum remover into the tub and let it sit for 10 to 15 minutes. Clean the tub with a sponge or washcloth, and then rinse it with warm water.

You can also use this mixture to eliminate hair dye stains in the sink. Just spray it on the dye and wait. Use an old rag or sponge to rub it, and then rinse it clean.

Using Vinegar to Clean a Bathtub

White vinegar isn’t just something you always have in your kitchen. It’s also a safe and natural way to clean the bathroom instead of using harsh commercial products that contain dangerous chemicals.

Vinegar is a great cleaner that can be used on almost every exterior in your bathroom, from the bowl to the bathtub to the shower door. You can even use vinegar to clean a tub that has jets. The vinegar’s high acidity helps remove mineral deposits from hard water and removes soap scum. It also works well for cleaning the sink in the bathroom.

To get rid of soap scum from a bathtub:

  1. Mix the vinegar, distilled water, and dish soap in a spray bottle.
  2. Put the lid back on and mildly shake to mix the ingredients.
  3. Spray all of the tub’s surfaces.

Scrub the whole bath with a nylon scrub brush. The nylon brush is slightly rough, making it easier to get rid of soap scum and also dirt without scratching the tub. Run hot water over the interior of the tub to clean it.

How to Take advantage of Bleach to Clean a Bathtub

Bleach has been used for a long time to clean bathrooms because it kills mold, mildew, fungus, viruses, bacteria, and other germs. It does a great job of cleaning not only acrylic tubs and plastic tubs but also jetted tubs and spa tubs.

Before using bleach to clean your tub, ensure you are in a well-ventilated area so that you don’t pass out from the fumes.

If you can’t open a window, turn on the exhaust fan and consider putting on a face mask as an extra safety measure. Wear rubber gloves to keep the bleach from getting on your skin. And don’t touch your eyes to keep your eyes from getting hurt.

Start by running warm water through the tub. Mix 1 gallon of water and also 1/2 cup of bleach in a large bucket. To clean the bathtub with the solution, use a soft cloth.

Use a small amount of bleach and baking soda to make a paste. Use this paste to get rid of built-up residue and hard soap scum.

Add a little water to the paste, and then use a cleaning brush to rub the tub in a circular motion until the paste is gone. Rinse out the tub with cold water and let it dry.

Read Also: How to Clean a Bathroom Fan With Light

How to Use Borax to Clean a Bathtub

Borax is the answer if you want to clean your bathtub without scrubbing. Borax has been used for cleaning for a long time, just like baking soda.

When hot water and borax are mixed, some borax molecules change into hydrogen peroxide, which helps bleach and clean. Just sprinkle some Borax on the bottom of the tub to get rid of hard water stains, hair dye, soap scum, and rust stains. It’s a part of a special rust remover for tubs that we’ve discussed.

Scrub it into the tub’s surface with a sponge or soft-bristled brush, then rinse with warm water to remove the residue.

Fill a spray bottle with the first four ingredients. Next, add the water slowly. Put the spray bottle’s top on and gently shake the bottle to mix the ingredients.

Every time you use the bathtub, spray the surface with water. You don’t have to rinse the cleaner off or wipe it off.

If you spill paint on a bathtub while remodeling, you might find that this works to get the paint off.

Cleaning a Fiberglass Bathtub

Cleaning a fiberglass tub is different from cleaning a porcelain tub. In contrast to a porcelain tub, using an abrasive cleaner on a bathtub can damage the surface. Fill up a tub or bowl with warm water to remove hard water stains and also soap scum and bring back the shine on a fiberglass tub.

Stir some baking soda and vinegar into the water. Use the cleaning solution on a sponge to gently clean the tub’s surfaces. Rinse the surface with warm water and make sure to get rid of any leftover soap.

This is also a great way to clean a hot tub and remove hard water stains and dirt. Use a daily bathtub cleaner, like the one above, to finish.

Mix soda and water to make a cleaning paste that removes even the most stubborn dirt. Use a damp wipe to rub the paste into the spots that are giving you trouble.

Rinse the area with water, and if necessary. Do it again to ensure the stain is gone. You can also use these tips to clean a fiberglass shower, which will make your bathroom shine like new.

People often put off cleaning the bathtub and bathroom as long as they can. But if you wish for a nice relaxing bath after a long, stressful day, you must keep the tub clean. With these simple tips, you can clean even the dirtiest bathtubs quickly and easily.